Threaded Insert and Hex Key for Integrated Thread Stand
SKU: 104152
Threaded Insert and Hex Key for Integrated Thread Stand
SKU: 104152
Summary
Transfer your Sailrite Integrated Thread Stand from your case to a sewing table with this extra threaded insert and hex key.
Jump To:
You May Also Like
Industrial Bobbin Winder
#103276
Allen Wrench 3/32"
#102264
Thread Guide Needle Bar for SR200
#100211
Euro Hinge for Power Stand Tabletop
#100544
Rubber Base for Euro Hinge
#100578
K Leg Foot Treadle
#100762
Treadle Linkage Bar
#100763
Drawer for Power Stand
#100764
Support Pin for Power Stand
#100766
Take-Up Arm Guard for Ultrafeed® & Leatherwork®
#102626
Needle Guard for 220–240V Ultrafeed® & Leatherwork®
#102627
Belt Cover Red for Small Diameter Wheel Ultrafeed® LS
#102628
Belt Cover Blue for Small Diameter Wheel Ultrafeed® LSZ
#102631
Tabletop for Professional® Long Arm
#102737
Lift Bar for Professional®
#102232
Retaining Ring for Ultrafeed® & Leatherwork®
#102241
L,R,C Lever Stop for Ultrafeed® LSZ
#103254
Needle Crank Arm for Ultrafeed® & Leatherwork®
#103269
L,R,C Lever Pin for Ultrafeed® LSZ
#103270
Needle Bar Thread Guide Holder for Big-N-Tall
#103290
Description
Order this item to create an additional mount location for the Integrated Thread Stand. Use the same thread stand in the Industrial Carrying Case, the Ultrafeed® Wooden Base or on a sewing table. Just loosen the thumb screw and tighten the stand in the second mounting location.
To install the threaded insert use a 5/16" drill bit to drill a 1" hole. Place the threaded insert squarely in the hole. Use the provided Hex Key, turning clockwise, to screw the threaded insert until the flange is flat with the table.
Note: this item is included with the #103658 Integrated Thread Stand.
Specifications
Specifications
| Brand | Unbranded |
|---|